Rail Cap Installation
Installation should take less than 5 minutes.
1. Open your camper side panels.
2. Locate the access ports on the frame of your camper.
3. Align the rail cap with the seal side toward the access port.
4. While applying even pressure with two hands, firmly press rail cap into place. Caution – Do not use too much force as this may cause damage to the rail cap and possibly cause injury.
Caring For Your Rail Caps
When you install these rail caps they will snap on. The small pieces that hold the rail cap in place are meant to be installed one time. Removing the rail cap may damage it and degrade it’s ability to snap back on.
Please remember, dropping 3D printed items can cause damage to them. If they are dropped, inspect them for any damage before using.